Installing The S; Tellar - Barco STELLAR User And Service Manual

2
N

Installing the S

Rack mounted
To mount the S
To apply power
16

Installing the S

TELLAR

TELLAR

The S is a 1U unit with connector access at the rear panel. The S
TELLAR
intended for mounting in a standard 19" rack.
To mount the S
TELLAR
TELLAR
1. We recommend that you mount rails in the rack to support each S
be installed.
For further information, contact your rack supplier.
2. Place the S
TELLAR
3. Mount the S
TELLAR
the front panel mounting flanges.
4. Mount a 1 U (44 mm) air separation plate between each S
Air intake
Air intake
Air intake
The order no. of the air separation plate is 978751. The air separation plates are
mandatory as they also serve as a fire enclosure, preventing spread of fire.
The S is powered by AC or DC. To apply power to the S
TELLAR
lowing:
1. Connect the power cord to the power inlet.
2. When DC-supplied, connect the S
bution module or a bus bar being part of the rack.
3. Make sure that the power cable is connected to protective earth or use the
ground stud.
in a rack do the following:
in its position in the rack.
securely to the rack by securing 4 screws in the holes in
to the DC source through a distri-
TELLAR
is
TELLAR
to
TELLAR
.
TELLAR
Air outlet
Air outlet
Air outlet
do the fol-
TELLAR