Connecting To The Ts Output; Connecting To The Smpte 310M Output - Barco STELLAR User And Service Manual

2
N

Connecting to the TS output

To connect to the TS
output
N

Connecting to the SMPTE 310M output

To connect to the
SMPTE 310M output
22

Connecting to the TS output

To establish the TS output connection, connect the TS cables to the interface connec-
tors. The following connector is available:
Connector
ASI restamping
output
To establish the SMPTE 310M output connection, connect the SMPTE cables to the
interface connectors. The following connector is available:
Connector
SMPTE 310M
output
Interface Connector type
BNC.
2 connectors.
The output bit rate can be freely set
between 1.0 and 92 Mbit/s. If you set
the bit rate lower than the bit rate of
the network input there has to be an
overhead of null packets in the
incoming TS stream corresponding
to the bit rate reduction.
Interface Connector type
BNC.
Two 75 Ω connectors with identical
output. The output bit rate is always
19.39 Mbit/s.