Mbit/S - G.703 (Ds3) - Barco STELLAR User And Service Manual

N
45 Mbit/s – G.703 (DS3)
Settings
Network source
Network frame
Network input format
BER alarm threshold
Network input status
The following settings are available in the 45 Mbit/s - G.703 menu:
Parameters A/B/Auto
Description You may select the specific network input A or B or you may set
the S
TELLAR
Parameters Off, G.804, G.752
Description The framing must be the same in the encoder and decoder.
Display 188 RS OFF, 204 RS ON
Description This is a status display. "188 RS OFF" means that the Reed
Solomon algorithm is not applied.
"204 RS ON" means that the Reed Solomon algorithm is applied.
-9
Steps 10e to 10e
Description LO: Set a value that represents a service degradation for your
application. You cannot set the threshold to a higher value than
the one selected for the high threshold.
HI: Set a value that represents a service loss for your application.
You typically set the HI threshold to 10e
Display Present, None
Description This is a status display showing whether the S
detected an active network input line or not.
to autodetect the active network input.
-3
45 Mbit/s – G.703 (DS3)
3
-3
.
has
TELLAR
43