Barco STELLAR User And Service Manual page 136

5
No. Information
7 Communication
port error
2 Contact closure
occurred
34 Device software
error
36 Hardware failure
37 Module
configuration
error
40 MPEG PSI error
124
ROSA messages
Name Enabled Severity
Communica On Information Disable
tion error
Close On Information Disable
Open On Information Disable
General Off Information Disable
software
error
RTK related Off Information Disable
SW error
Module On Information A
hardware
error
Module On Information B
selftest error
Misplaced On Major
module
Module is On Major
removed
Module is On Major
unknown
No module On Major
handler
Pig. On Major
misplaced or
missing
PCR On Major
accuracy
error
Program not On Warning
in PAT
Category Explanation/Remedy
Check the terminal settings.
One of the contact closure contacts has
closed and thereby activated a macro.
Reload the ROSA windows to get the
actual settings from the decoder.
One of the contact closure contacts has
opened and thereby activated a macro.
Reload the ROSA windows to get the
actual settings from the decoder.
A software error has occurred. When
persistent, contact your local BARCO
sales office for further assistance.
A software error has occurred. When
persistent, contact your local BARCO
sales office for further assistance.
Replace the module in question.
The self-test has failed. Replace the
module in question.
B A module was missing at power-up or a
known module was misplaced.
B A module is missing. Replace the module
or make a new configuration.
B The module is not known by the system
controller. The module stock number may
be lost or your system controller software
is too old to handle the module.
A The stock number of the module is not
known to the system controller. Check the
stock number and slot position of the
module. Check if the firmware supports
the module.
B The reference check of the piggy-back
module failed, indicating that the module
is either misplaced or missing.
A The PLL cannot lock to the PCR values
due to inaccuracy (e.g. excessive jitter,
frequency error, etc.). Set the Video
Synchronization mode to "Free Running".
B The selected program is not found in the
PAT. Check the source and select the
correct program.