Navigating And Editing - Barco STELLAR User And Service Manual

N

Navigating and editing

Introduction
Navigating
To edit a parameter
This section describes how to navigate through the menus and how to edit the set-
tings.
There are three different ways of navigating through the menus.
Keys
With the 4 cursor keys you can move left and right to access
Cursor
the different main menus. In each menu you can scroll down
(and up) to access the different parameters for the chosen
main menu.
If you want to go to another menu, you have to go upwards to
the top item and then move left/right again. To do this quicker
you can use one of the following methods.
By using the shortcut keys, you can jump directly from your
Shortcut
current position to the top of the most important menus:
NETWORK, PROGRAM, PRESET, CONFIG, STATUS.
Then you can use the cursor keys to scroll downwards.
When you have moved downwards in one of the menus and
Esc key
you want to go back to the top, you can press the Esc key,
instead of scrolling all the way up again.
Not implemented yet.
User
When you have navigated to the parameter you want to change, use the following
procedure:
1. Press Enter to go into edit mode.
2. Use the cursor keys to change the value.
You do this either by scrolling through a list of possible settings, or by changing
each digit of a number, for example a bit rate. If you have changed a setting and
realize that you do not want to change it anyway – press Esc – and the original
value is restored.
3. Press Enter to confirm the new value and leave the edit mode.
Function

Navigating and editing

3
39