Barco STELLAR User And Service Manual page 138

5
No. Information
33 Power supply
failure
51 System
configuration
error
54 System event
16 Video output error Genlock ref.
126
ROSA messages
Name Enabled Severity
+15 V error Off Major
+3.3 V error Off Major
+5.0 V error Off Major
-15 V error Off Major
Alarm On Information Disable
queue lost
Configuratio On Information A
n error
Default lost On Information C
Product On Information B
check failed
SW options On Information B
lost
Download Off Information Disable
started
Off Warning
input loss
Video On Major
decoding
error
Category Explanation/Remedy
Disable The supply rail is not within the legal
range. It may compromise the operation.
Disable The supply rail is not within the legal
range. It may compromise the operation.
Disable The supply rail is not within the legal
range. It may compromise the operation.
Disable The supply rail is not within the legal
range. It may compromise the operation.
All messages from previous session(s) are
lost.
The detected configuration is different
from what has been defined. Revise your
module configuration.
The user-defined default settings are lost.
The decoder starts with factory defaults.
Change the settings, if necessary.
A module is found in a place where it's
not allowed. Remove the module.
The software options codes have to be re-
installed. Use the command SYStem :
OPTion : INSTall.
The decoder has entered download mode.
Download to a module has started.
Disable There is no genlock reference. The video
output runs at nominal frame rate. Check
your genlock reference feed.
A There is no valid video output due to
decoding errors. Check the source and the
condition of the input signal