Table of Contents
Advertisement
N
Alarms and messages
N
Alarms and message setup
Overview
Message setup window Messages are set up in the messages setup window of the S
The C
server reads the messages from the S
OPERNICUS
If you connect a PC locally, the alarm messages are queued and sent to the local PC
as soon as the local PC takes control over the S
In order to be able to read the messages, you must make sure that polling is enabled
in ROSA. Do as follows:
1. From the C
OPERNICUS
Properties.
2. Select the Settings tab.
3. Check the Poll Units box.
When the S
is not connected to ROSA, the messages from the S
TELLAR
queued in the decoder. This may result in some messages being acknowledged with-
out being reported to the ROSA management system. The S
to 256 messages. When the message buffer is full the new messages overwrite the
oldest ones.
When you click the Messages tab and reload a message (using the right mouse but-
ton) the Message setup window is updated. The following screen is an example of a
Message setup window. For a list of all the potential messages in the S
ROSA messages, p. 123.
TELLAR
.
TELLAR
Explorer, right-click on the COM-port and select
Alarms and message setup
4
.
are
TELLAR
may contain up
TELLAR
explorer.
TELLAR
, see
TELLAR
101
Advertisement
Chapters
Table of Contents
