Setting Up The General Message Parameters - Barco STELLAR User And Service Manual

N

Setting up the general message parameters

To set up the general
message parameters
Change of alarm
sequence
The general message parameters influence the whole message system and are thus
common to all messages. Do as follows to set up the general message parameters:
1. Check the Messages enable box.
This means that messages are displayed in the ROSA Message View. The S
does not generate messages if you un-check the Messages Enable box. This
LAR
is valuable in a service situation, where the unit is being reconfigured.
2. Select Alarm Sequence 1, 2 or 3 from the Sequence scroll list.
The alarm sequences control the alarm relays and the alarm LEDs on the front
panel in different ways:
Alarm Press front panel button
Sequence for Receiving Attention
1 For each active alarm
press Receiving Attention.
2 Half automatic. For each
active alarm press
Receiving Attention.
3 Automatic. Pressing
receiving attention has no
function.
For further information on alarm sequences and Receiving Attention, see
handling, p. B-1.
If you change the alarm sequence to one with fewer categories, the alarms will
behave according to the new sequence as shown in the table below.
Sequence change Category behavior
3 to 1 Categories D and E behave as category A
3 to 2 Categories C, D and E behave as category A
1 to 2 Category C behaves as category A
Note! Such a sequence change does not affect the previously stored categories.
This means that if you, by accident, change your alarm sequence you
get the stored categories back by reverting to the original alarm
sequence.
When the alarm is no longer
present
press Receiving Attention again for
each alarm cleared.
the alarm is automatically cleared.
The alarm LEDs on the front panel
turn off.
the alarm is automatically cleared.
The alarm LEDs on the front panel
turn off.

Setting up the general message parameters

4
-
TEL
Alarm
103