V.35 Input - Barco STELLAR User And Service Manual

N

V.35 input

Settings
V.35 network input
mode
Network input format
BER alarm threshold
Network input status
The following settings are available in the V.35 input menu:
Parameters E1 or T1 and 1 to 6
Description You select the number and type of transmission lines (E1 or T1)
between the I-MUXes. For E1 you can select from 1 to 5 and for
T1 from 1 to 6 transmission lines.
Display 188 RS OFF, 204 RS ON
Description "188 RS OFF" means that the Reed Solomon algorithm is not
applied.
"204 RS ON" means that the Reed Solomon algorithm is applied.
-9
Steps 10e to 10e
Description LO: Set a value that represents a service degradation for your
application. You cannot set the threshold to a higher value than
the one selected for the high threshold. You typically set the LO
threshold to 10e
HI: Set a value that represents a service loss for your
application.You typically set the HI threshold to 10e
Display Present, None
Description This is a status display showing whether the S
detected an active network input line or not.
-3
-4
.
3
-3
.
has
TELLAR
45

V.35 input