Barco STELLAR User And Service Manual page 38

2
To terminate the
reference input
26
Connecting the output signals
5. Connect the N x 64 kbit/s data output to the connector marked N x 64 kbit/s
OUT.
You must terminate the reference input:
1. Connect a T-piece to the reference input connector.
decoder connector panel
Black and burst com-
posite reference input
.
2. Connect a terminator to the other end of the T-piece.
3. If you are using a second S
input of the second S
TELLAR
4. Connect the open end of the T-piece of S
ence input at S
TELLAR
5. Connect a terminator to the other end of the T-piece at S
Ref. input connector
T piece
, connect theT-piece at the reference
TELLAR
.
1 to the T-piece at the refer-
TELLAR
2.
to a second
decoder
or
Terminator
99-038
2.
TELLAR