Setting Up The Inserted Vbi - Barco STELLAR User And Service Manual

4
N

Setting up the inserted VBI

To set up the inserted
VBI decoding
88

Setting up the inserted VBI

From this picture you set up the VBI signals that the decoder should generate.
Do as follows to set up the inserted VBI decoding:
1. From the Codec Explorer right-click on the video you want to set up and
select Properties.
2. Click the Inserted VBI tab.
3. Click GCR.
This enables Ghost Cancellation Reference signals. GCR is inserted in line 318
in PAL systems and lines 19 and 282 in NTSC systems.
Ghost Cancellation Reference is only available for PAL and NTSC outputs, and
for SDI outputs if embedded VBI is enabled.
4. Click Embedded VBI if you want to embed VBI in the SDI signal.
Enabling Embedded VBI results in all composite VBI data being embedded into
the SDI output.
The individual VBI elements can be enabled/disabled from their individual pic-
tures.
5. Click EDH if you want to include EDH in the SDI signal.
Transparent EDH means that the EDH flag is transferred transparently from the
encoder to the decoder; i.e. the encoder EDH flags are untouched. If the decoder
does not receive any EDH flags from the encoder it sets all flags to UES.
(Unknown Error Status).
Internal means that EDH signals are generated in the decoder and all EDH flags
are cleared. For further information on S
Detection and Handling (EDH), p. C-1.
and EDH flags, see
TELLAR
Error