Barco STELLAR User And Service Manual page 36

2
Auxiliary data output
RS-232 aux. pin
allocation
RS-422 aux. pin
allocation
N x 64 kbit/s data
24
Connecting the output signals
mono is output on both connectors.
The digital AES/EBU audio output for audio channel 1 is connected to
the XLR connector marked AUDIO OUT 1 AES/EBU.
One unidirectional auxiliary data channel may be decoded from the incoming data
stream. The auxiliary data channel which was assigned to the video channel will be
decoded in the decoder. The auxiliary data is output on both the AUX RS-232 and the
AUX RS-422 connector.
The following table shows the connector and the pin allocation for the RS-232 data
output.
Connector
1: Not connected
1
2: RxD (output)
3: Not connected
4: DTR (input)
9
5: Ground
6: DSR (output)
7: Not connected
8: CTS (output)
9: Not connected
The following table shows the connector and the pin allocation for the RS-422 data
output.
Connector
1: Shield
1
2: TxA (output)
3: Not connected
4: Ground
9
5: Not connected
6: Ground
7: TxB (output)
8: Not connected
9: Ground
A synchronous N x 64 kbit/s data channel (N is one to six) may be decoded from the
incoming data stream. The data is output at the N x 64 kbit/s Out connector.
Pin allocation
Transparent data channel
RS-232-E, at a bit rate of 600
to 38400 baud.
Connector type: 9-pin sub-D
female.
Pin allocation
Transparent data channel
RS-422, at a bit rate of 600 to
38400 baud.
Connector type: 9-pin sub-D
female.
Output signal
Output signal