5Th Wheel Operation; Unhitching Instructions; Auto Level; Hitch Recognition - Lippert Components Level Up Installation And Owner's Manual

5th Wheel Operation

Unhitching Instructions

1. Push touch panel "ON/OFF," (Fig. 30K) to turn system
on. LCD Screen (Fig. 30E) lights up.
2. LCD will display status ... "NOT Level JACKS: UP"
(Fig. 31A).
3. Orange arrow lights (Fig. 31B) may come on, indicating
the current disposition of the unit.
4. Push "FRONT" button (Fig. 30G) to extend landing gear
jacks and lift front of unit to take the weight of the 5th wheel
off of the hitch.
5. Uncouple the 5th wheel connection on the tow vehicle.
6. Pull tow vehicle away and park at a safe distance.
A
Fig.31

Auto Level

NOTE: Prior to unhitching from the tow vehicle, ensure
unit is parked on a level surface and chock the tires of
the unit.
1. After unhitching from tow vehicle press "AUTO
LEVEL" (Fig. 30F).
NOTE: Pressing any button during an Auto Level
sequence will abort the auto leveling cycle.
lci1.com 574-537-8900
B
Level Up
Installation and Owner's Manual
(For Aftermarket Application)
NOTE: In order for hitch recognition feature to function, the
MUST
auto level sequence
unit above level.
Auto Level Sequence
1. Front landing gear retract, lowering the front of the unit
below level, stopping, then lifting the front end to level the unit
front to back.
2. The left side leveling jack(s) extend and raise the roadside
of the unit.
3. The right side leveling jack(s) extend and raise the curbside
of the unit, beginning side to side leveling.
4. The front landing gear extend to complete the leveling cycle.
5. Additional left to right or front to back leveling may occur if
the controller deems necessary.
NOTE: If the auto level sequence does not happen as stated
above, check to ensure proper manual function in all zones.

Hitch Recognition

1. Turn on touch pad.
2. Press the left and right buttons simultaneously
(Fig.30H and 30I).
3. The front of the trailer will raise to the height where
the auto level sequence was started.
NOTE: If the auto level sequence was started with the
front of the trailer in a below-level condition, the Hitch
Recognition will not function and the LCD will display
"Feature Disabled." In order for hitch recognition feature
to function, the auto level sequence must be started
with the front of the trailer above level.
4. Connect tow vehicle and make sure 5th wheel and
hitch are connected and locked.
5. Push "UP" arrow until "AUTO RETRACT" appears in
LCD screen.
6. Push "ENTER". System will immediately retract all
jacks.
13
CCD-0001533
™
be started with the front of the
Rev: 06.29.18