Operation - Power Tongue Jack; Unhitching From A Tow Vehicle; Reconnecting To Tow Vehicle - Lippert Components ground control TT Owner's Manual

Operation - Power Tongue Jack

Be sure to park the trailer on solid and level ground. Prior to operation, clear all jack landing locations
of debris and obstructions. The locations should also be free of surface depressions and moisture. When
parking the trailer on extremely soft surfaces, utilize load distribution pads under each jack.
NOTE: The "On" and "Off" switch (Fig. 2A) controls the Power Tongue Jack's light only. If left on for an extended period of
time, the light will drain the trailer's battery.
NOTE: The Power Tongue Jack is designed for vertical movement of the trailer only.

Unhitching From A Tow Vehicle

NOTE: Prior to unhitching from the tow vehicle, ensure trailer is parked on a level surface and chock the tires of the trailer.
NOTE: Ensure the foot pad of the Power Tongue Jack is pinned securely in place with the clevis pin and hairpin cotter pin
(Fig. 1B).
1.
Disconnect any wires, chains, or sway control that may be equipped between the tow vehicle and the trailer. Unlatch
the trailer coupler.
2.
Push "EXT" (Fig. 2C) two times holding on the third time approximately 5 seconds, then release the switch and the
Power Tongue jack will automatically extend to the ground.
3.
Push "EXT" until the coupler clears the hitch ball.
4.
Disconnect the trailer wire connection at the tow vehicle, if not previously completed.
5. Move the tow vehicle away from the trailer.
6.
Push "RET" (Fig. 2B) as needed to return the front of the trailer to level or use the Auto Level function to level the trailer
per the instructions in this manual.

Reconnecting to Tow Vehicle

1.
Chock the tires of the trailer.
2. Press "EXT" (Fig. 2C) if needed to allow the coupler to clear the hitch ball.
3.
Push "RET" (Fig. 2B) to retract the Power Tongue Jack until the coupler properly mounts the hitch ball and the leg.
4.
Latch the tow vehicle hitch and connect any wires, chains or sway control that may be equipped between the tow
vehicle and trailer.
5.
Press "RET" two times and hold on the third time approximately 5 seconds until the Power Tongue Jack pauses. Let go
of the switch and the Power Tongue Jack will automatically retract.
NOTE: Be sure the leg of the Power Tongue Jack (Fig. 1A) is fully retracted prior to moving the tow vehicle.
A
B
Rev: 11.13.2017
Fig. 1
A
Page 4
Fig. 2
B
C
Ground Control TT Leveling OCTP Owner's