Setting And Adding The Ecc800 Collector; Setting Neteco Parameters - Huawei FusionModule1000A Commissioning Manual

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide

8.4.2.2 Setting and Adding the ECC800 Collector

The requirements for ECC800 WebUI login are as follows.
Computer operating system: Windows 7 and later versions
Browser: IE11 and later versions; Firefox and later versions; Chrome and later versions

8.4.2.2.1 Setting NetEco Parameters

When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 8-13 IP parameters
Path
System
Settings >
System
Parameters
> Monitor
Module
IP >
WAN_1
Step 3 Set NetEco communications parameters on the ECC800 WebUI.
Table 8-14 NetEco parameters
Path
System
Settings >
NMS
Application >
NetEco >
Communicati
on
Parameters
Issue 02 (2019-12-20)
Parameter Default
Value
IP 192.168.1.10
Subnet mask 255.255.255.
0
Default 192.168.1.1
gateway
Parameter Default
Value
Server IP 192.168.8.1
1
Port number 31220
Link to the WAN_1
monitoring IP
address
Copyright © Huawei Technologies Co., Ltd.
8 Commissioning Core Components
Setting Value
Set this parameter based on the IP address
assigned by the network administrator.
Set this parameter based on the subnet mask
assigned by the network administrator.
Set this parameter based on the default
gateway address assigned by the network
administrator.
Setting Value
IP address of the primary NetEco server
NOTE
The NetEco IP address and the ECC800 IP
address must be configured in the same
network to ensure normal connection
between the NetEco and the ECC800.
31220
WAN_1
92