Huawei FusionModule1000A Commissioning Manual page 75

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide
Parameter
cooling
product
address
Enable
Teamwork
CAN
resistor
Teamwork
function
Networking
mode
Number of
Issue 02 (2019-12-20)
Description
addresses should be
different from each
other.
Indicates the build-out
resistor status of each
smart cooling product
in a teamwork group.
Set the parameter if
CAN network is used.
Disable or enable the
teamwork function. If
the teamwork function
is disabled, this device
is operating according
to its own control. If
the teamwork function
is enabled, this device
works in harmony with
others that in the same
group.
Networking mode for
the teamwork. The
networking mode set on
the screen must be
consistent with the
actual networking
mode. Otherwise, the
teamwork control
function will be
unavailable. If the
networking mode
changes, select the
corresponding
networking mode on
the screen. If the
networking mode is
changed on the screen,
the software will restart
and then run in the new
networking mode.
Number of the smart
Copyright © Huawei Technologies Co., Ltd.
8 Commissioning Core Components
Configuration
Principle
address.
 Set this parameter
to No for
non-teamwork
scenarios.
 For teamwork
scenarios, set this
parameter to Yes
for the first and last
smart cooling
products in a
teamwork group,
and set it to No for
other smart cooling
products.
Set this parameter
based on the onsite
device heat
distribution.
Networked over CAN
or MAC_CAN. CAN
network indicates
teamwork control over
a CAN bus,
MAC_CAN network
teamwork control over
an FE port.
Total number of the
Default Value
No
Disable
CAN network
3
68