Huawei FusionModule1000A Commissioning Manual page 36

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide
Table 6-1 Checking after power-on
System
Power supply
and distribution
system
Cooling system
Management
system
Issue 02 (2019-12-20)
Check Item Check
Sub-item
Integrated UPS MDU
Air cooled Remote
precision smart temperature and
cooling product humidity (T/H)
sensor
Controller
Monitoring Camera
device
ECC800
collector
Smart ETH
gateway
AC actuator
WiFi converter
Access control Pre-fab. module
system door
Copyright © Huawei Technologies Co., Ltd.
6 Power-On Commissioning
Criteria
 The screen is free from erratic
display or missing characters.

Settings meet the requirements
of the current scenario.
 The mains and bypass input
and output voltage, power,
frequency, current, power
factor, electricity energy, and
switch status are properly
displayed.
 There is no active alarm whose
severity is higher than minor.
If there are any alarms, record
and handle the alarms.
 The DIP switch settings are
the same as the initial settings.
 The screen is free from erratic
display or missing characters,
and displays no alarm.
 The teamwork settings are the
same as the initial settings.
The red indicator inside the
camera is on.
 The power indicator on the
main control board is on.
 The indicator on the power
module is green.
The PWR and RUN indicators are
on.
The PWR, RUN, and RF_Z
indicators are on.
The RUN and WiFi indicators are
on, and the WPS indicator is off.
 The magnetic lock indicator is
green when the pre-fab.
module door is closed.
 The magnetic lock indicator is
red when the pre-fab. module
door is open.
 The pre-fab. module door can
29