Amtech Axpert-Eazy Series Instruction Manual page 24

This key is used to change and save the parameter value. When pressed first time, it will
allow the user to change the parameter value using up and down keys. Once the desired
value is set, it is pressed again to save the change value. Press NORM key instead of
ENTER, to discard the change.
This key is used to start the AC DRIVE when the start control is through Digital
Operation Panel. The key is equipped with the status indicating LED. It will glow, when
the AC DRIVE is running.
3
This key is used to stop the AC DRIVE in LOCAL mode (keypad) only. When stop key is
pressed for 2.5 seconds or longer during operation, the drive will coast to stop
regardless of Local or Terminal start control. It is also used to reset the fault. The stop
key is equipped with status indicating LED. It will glow when the AC DRIVE is off.
The Digital Operation Panel is also equipped with the fault indicating LED. It will flash in the fault
condition. It is also equipped with four lines, 20-character LCD display for the user-friendly parameter
navigation, monitoring and setting.
In the normal condition the screen will be as below.
Amtech
3.2
The GROUP + DOWN key passes the control to previous group in the same
mode. The groups can be accessed in the reverse direction. At last it will
again come to the same group.