Testing The Circuit Diagram - Eaton easyE4 Manual

4.5.2 Testing the circuit diagram

Press the cursor button
The cursor will move to the coil field.
Press the OK button.
The specified coil function and the output relay
be changed.
Your result will look as follows: Your first wired and functional circuit diagram
I001---I002---------Ä Q001
L:1 C:5
Figure 74: Completed circuit diagram
You can use the cursor buttons to access the part that is not visible.
Press the ESC button to leave the circuit diagram display.
Line 6 will show the SAVE menu option.
Saving
I001---I002--------------Ä Q001
SAVE
Figure 75: SAVE menu option in the status line
Press the OK button to confirm.
The circuit diagram is stored.
Press the ESC button twice to return to the main menu.
You can test the circuit diagram if the S1 and S2 buttons are connected.
Go back to the main menu.
Select the STOP RUN menu option.
The current operating mode is indicated on the display of the easyE4 device by a tick
at RUN or STOP stop. Pressing the OK button enables you to toggle between the modes.
Press the OK pushbutton in order to change to RUN.
The Status display also shows the current mode set.
easyE4 10/19 MN050009 EN www.eaton.com
once more.
Q001
40120
4. Operation
4.5 Your first EDP program
are correct and do not have to
149