Eaton easyE4 Manual page 498

6. Function blocks
6.1 Manufacturer function blocks
494
Operators
Constant 0, constant 1
M – Markers
2)
RN - Input bit via NET
SN - Output bit via NET (send)
2)
N - Net marker bit
2)
nN - NET marker bit NET station n
ID: Diagnostic alarm
LE - Output backlight
P device buttons
I - Bit input
Q - Bit output
Q - Bit output of a FB
2) Only on projects with ≥ 2 base devices on NET
Operating mode
Operating mode
Q = Reset outputs
M = Reset marker
ALL = Reset both
Function block outputs
Description
(Bit)
Q1 1: If input T_ has a state of 1.
Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
MB, MD, MW - Markers
NB, NW, ND - NET markers
NET stations n
QA - Analog output
I - Value input of a FB
2) Only on projects with ≥ 2 base devices on NET
You can assign the following operands to the function block outputs that are bit outputs:
easyE4 10/19 MN050009 EN www.eaton.com
Bit inputs
x
x
x
2)
x
x
x
x
x
x
x
x
x
Description
Device outputs Q.., and QA..., as well as outputs
LE.., SN.., will be reset to a state of 0.
The following markers are reset to 0:
Marker range MD01...MD256
l
ND01..ND16
l
Internal markers of existing function
l
blocks UF, IC, IE and IT
Has an effect on the operands set at Q and M.
Note
Value outputs
x
2)
x
x
x
Note
Default
settings