Eaton easyE4 Manual page 611

Delay time with debounce deactivated
If the debounce option is disabled, the delay time will decrease. If a positive half wave
is detected, the easyE4 device will directly switch the corresponding input (contact)
from 0 to 1 (A) internally.
S1
1 2
t
SC
A
Figure 270: Switching behavior of AC input signal with DEBOUNCE deactivated
If a positive half-cycle is not detected the easyE4 switches off the contact (B).
Switch-on delay (normally):
l
I1 ... I8: 25 ms (21 ms)
l
Off-delay (normally):
l
I1 ... I8: 25 ms (21 ms)
l
The appropriate values for 60 Hz are given in brackets.
For more information on how to change the delay times, please
refer to → Section "Time behavior of the inputs and outputs",
page 603
easyE4 10/19 MN050009 EN www.eaton.com
8.6 Device easyE4 time responses
1 2
B
8. easyE4 Inside
607