Eaton easyE4 Manual page 447

Parameter set
at input EN
Parameter display
+ Call enabled
Type of information trans-
mission
Recipient assignment
Subject
Message text
Simulation possible
Other
Retention
The function block does not recognize retentive data.
See also
→ Section "E-mail function", page 670
→ Section "BV - Boolean operation", page 444
→ Section "D - Text display", page 448
→ Section "D - Text display editor", page 458
→ Section "DL - Data logger", page 475
→ Section "JC - Conditional jump", page 486
→ Section "LB - Jump label", page 491
→ Section "MR - MasterReset ", page 493
→ Section " NC - Numerical converter", page 497
→ Section "ST - Set cycle time", page 503
easyE4 10/19 MN050009 EN www.eaton.com
Description
must not be permanently enabled; go to
→ "Webserver tab", page 646
Constants can be edited on the device,
as can function block parameters when
using the EDP programming language.
E-Mail; there are no other options as of
this writing
Used to select one of the three possible
recipient groups. Each recipient group
contains all the detailed information
required in order to send an e-mail.
1 recipient group; there are no other
options as of this writing
The e-mail's subject
The text must not exceed 160 char-
acters.
6. Function blocks
6.1 Manufacturer function blocks
Note
Each recipient group needs to be
set up in the hardware con-
figuration. To do this, click on "Pro-
ject" – select a base device – click
on the "E-Mail" tab. You can then
configure the e-mail server and
one or more e-mail recipients for
each of the three available groups.
443