Eaton easyE4 Manual page 225

Parameter definition at the function block
If + Call enabled is selected for the function block under Function block dia-
gram/Parameters/, it will be possible to change the switching times in the PARAMETER
menu on the device while in RUN / STOP mode.
The time to be entered must be between 00:00 and 23:59.
Table 71: Incomplete and automatic parameter definition at the function block
Day Hour
-
DY1 e.g. Mo
DY2 e.g. Fr
DYx = Weekday
It is therefore not possible to enter the time only. If you delete the weekday (DEL button)
whilst making an entry or during operation or simulation, the time will be deleted auto-
matically. Entering the time automatically causes Sunday to be entered as the default
weekday.
Other
Retention
The function block does not recognize retentive data.
Behavior in the event of a power failure
The time is backed up and refreshed in the event of a power supply failure. In this case,
the time switches no longer switch and the contacts are kept open, Q1=0.
Information on the battery back-up time are provided on → Section "Back-upof real-
time clock", page 702
After being switched on, the control relay will always update its switching
state based on all existing switching time settings and will switch Q1
accordingly.
easyE4 10/19 MN050009 EN www.eaton.com
Minute Result
- - A switch point will not be set if you have not set
the weekday or the time.
Device display: -- --:--
- - If you only set the weekday for the On time, the
programming software will automatically set the
Hour and Minute values to 00. The contact
remains active, if the Off Time has not been set.
Device display example: Mo 00:00/-- --:--
- - If you only set the weekday for the Off time, the
programming software will automatically set the
Weekday for the On time to Sunday and Hour and
Minute values to 00.
Device display: Su 00:00/Fr --:--
6. Function blocks
6.1 Manufacturer function blocks
221