Microsdmemory Card; Microsd Ejecting The Memory Card - Eaton easyE4 Manual

3. Commissioning

3.9 microSDMemory card

3.9 microSDMemory card

3.9.1 microSD Ejecting the memory card

124
easyE4 base devices can be used with a microSD memory card.
The easyE4 device supports microSD memory cards with a capacity of 128 MB to 32
GB (SD and SDHC, FAT12/16/32, Class 2 or 4 ).
The following card manager functions for microSD memory
cards and the online function are not available in demo mode.
Moreover, using a memory card makes it possible to use the following functions:
1. Automatic booting from the memory card
The easyE4 can load and run a starting program from the memory card.
2. Resetting to factory settings
starting program
3. Download new firmware
4. Setting a splash screen for the EASY-E4-...-12...C1(P) display
You can store a boot.bmp file on the memory card so that it will be shown on the
display when starting the easyE4 and when inserting the card
5. Transferring user programs, Storing multiple programs
6. Logging data
→ Section "DL - Data logger", page 475
In order to be able to transfer programs or use the data logger function, the microSD
memory card must be formatted accordingly.
The actual transfer is carried out in easySoft 7, in the Project view.
The DL - Data logger function block can be used for logging data and states.
As an alternative to removing the memory card from the device, you can eject it with
easySoft 7.
There are two ways to do this:
Method 1
In easySoft 7, go to Communication view/Program/Configuration.
Click the Card... button.
In the Card setup dialog box, click on the Release button.
Method 2
In easySoft 7, go to Communication view/Display/Display + buttons.
Press OK to exit the display.
Make sure that the device is in STOP mode.
Use the P buttons to select the CARD menu option and confirm your selection with
easyE4 10/19 MN050009 EN www.eaton.com