Cursor Display; Entering Of Values - Eaton easyE4 Manual

4. Operation
4.1 Base device with display and buttons

4.1.4 Cursor display

4.1.5 Entering of values

130
The cursor buttons
Move
l
Enter
l
Connect
l
The current mode is indicated by the appearance of the flashing cursor.
Current selection flashes on the easyE4 display
In Move mode, use
œ
in order to select a rung, a contact or a relay coil or
the selection position of a coil function or a NET-ID.
I 01 Use the OK button to switch to Entry mode so that you can enter or change a
value at the current cursor position.
Press the ESC button in Entry mode
to restore to the last changes of an entry.
Press the ALT button to switch to Connect mode for wiring contacts and
l
relays.
Press the ALT button again to return to Move.
ESC Press the ESC button to leave the program (circuit diagram and parameter dis-
play).
ESC
OK
easyE4 10/19 MN050009 EN www.eaton.com
in the easyE4 program perform three functions:
to position the cursor on the circuit diagram
Used to select a position.
Use to select values
and/or a setting
Cancel, retain previous value
Store settings