Eaton easyE4 Manual page 627

The program and all project settings (i.e., the NET ID and Ethernet settings) for the selec-
ted NET station will be loaded onto the easyE4 device.
In the Project view work pane, select the next easyE4 device in the NET group.
Search for the devices in the NET group,
select the next device that should correspond to the next device in the project
from the list of found devices, and
go ONLINE, → Section "Establish connection to device", page 618.
In the Connection section, click on the PC => Device button.
Select the NET station.
Repeat these steps for every device that you want to configure in the project.
Project view
Figure 273: NET configuration with project and program
Connection parameters on device
The computer can use easySoft 7 to establish a connection without a project or pro-
gram and download the parameters for establishing a connection to each easyE4
device.
However, the Enable configuration via network option must be enabled on the
device. This is only possible if the project has been loaded, with the option enabled, onto
the device at least once – please refer to Enable configuration via network New.
In order to transfer these settings to the easyE4 device in the NET group, follow the
steps below:
easyE4 10/19 MN050009 EN www.eaton.com
10. Connection to other devices
623