Preparing The Card In The Easye4 Device For Booting With Easysoft - Eaton easyE4 Manual

3. Commissioning
3.6 Automatic booting from the card

3.6.2 Preparing the card in the easyE4 device for booting with easySoft 7

110
Prerequisites
Licensed easySoft 7 version on the PC
l
Insert the card into the device while the latter is de-energized.
Switch on the supply voltage.
Open easySoft 7 and open the project you want to transfer, e.g., <myPro-
gram.e70>.
If you want the starting program on the card to overwrite the current program on
the device again later on, make sure to enable the Allow overwriting via card
option in Project view/System settings tab.
Establish online communications between the PC and the device – please refer to
→ "Establish connection to device", page 618
If there is a program on the device already, make sure that the Allow overwriting
via card option is enabled in the program. To do so, enable the Allow overwriting
via card option in Project view/System settings.
Go to the Communication view/Program/Configuration section and click on the
Card... button.
The "Card setup" dialog box will appear.
easyE4 10/19 MN050009 EN www.eaton.com