Eaton easyE4 Manual page 324

6. Function blocks
6.1 Manufacturer function blocks
320
Operators
ID: Diagnostic alarm
LE - Output backlight
P device buttons
I - Bit input
Q - Bit output
Q - Bit output of a FB
2) Only on projects with ≥ 2 base devices on NET
Operating modes
Description
One-time mode The average value calculation will be completed
as soon as the specified maximum number of
input values to be included (NO) is reached.
Continuous oper- The average value will be calculated continuously
ation even if the maximum number of input values to be
included (NO) is reached.
The default setting is one-time mode.
Function block outputs
Description
(Bit)
RY 1: The average value calculation has been com-
pleted, since the specified number of input val-
ues to be included has been reached.
E1 Error
1: If the value range for I1 or NO is exceeded.
(DWord)
QV The current average value
QN The current number of values that were used in
the averaging calculation
Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
MB, MD, MW - Markers
NB, NW, ND - NET markers
NET stations n
QA - Analog output
I - Value input of a FB
2) Only on projects with ≥ 2 base devices on NET
You can assign the following operands to the function block outputs that are bit outputs:
easyE4 10/19 MN050009 EN www.eaton.com
Bit inputs
x
x
x
x
x
x
Value outputs
x
2)
x
x
x
Note
Note
Integer value range:
-2,147,483,648 to +2,147,483,647
Integer value range:
0...+2 147 483 647