Jumps - Eaton easyE4 Manual

5.4.15 Jumps

The power flow display does not show signal changes in the
millisecond range due to the inherent technical delay of LCD dis-
plays.
Jumps can be used for structuring a circuit diagram. They can replace the function of a
selector switch, for example, for Manual/Automatic mode or for different machine pro-
grams.
Jumps consist of a jump location and a jump destination (label). Jumps exist in the
circuit diagram, for skipping rungs:
l
Jump location and jump destination are located in the same circuit diagram
Function block editor, for skipping function blocks:
l
Jump location is located in the circuit diagram and jump destination in the function
block editor
The use of jumps in the function block diagram is explained in → "LB - Jump label",
page 491 and → "JC - Conditional jump", page 486.
The easyE4 device allows the use of up to 32 jumps.
Circuit diagram elements for jumps in the circuit diagram
Contact (N/O1)
Numbers 001 up to 032
Coils
Numbers 001 up to 032
Coil function , , , ,
1) can only be used as first leftmost contact
Function of jumps
If the jump coil is triggered, the rungs after the jump coil are no longer processed.
Jumps are always made forwards, i.e. the jump ends on the first contact with the same
number as that of the coil.
Coil = Jump when 1
l
Contact only at the first left-hand contact position = Jump destination
l
The jump destination is always an N/O contact with the status 1.
easyE4 10/19 MN050009 EN www.eaton.com
5. Programming on the device
5.4 Working with contacts and coils
181