Delete Program - Eaton easyE4 Manual

4. Operation
4.5 Your first EDP program

4.5.4 Delete Program

152
The DELETE PROGRAM function not only deletes the circuit diagram but all elements of
a program. These are as follows:
Circuit Diagram
l
Function block list
l
Function block diagram
l
Screens
l
The system settings and operating parameters are reset to the default settings and also
a possible NET parameterization.
Proceed as follows to delete the program in the easyE4 device:
easyE4 must be in STOP mode in order to extend, delete or modify the circuit diagram.
Switch the easyE4 device to STOP mode.
From the main menu, go to the SYSTEM OPTIONS menu.
Table 54: Main menu
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM
Select DELETE PROGRAM.
The easyE4 device will show a confirmation prompt.
Select YES.
Press the OK button to delete the program
Or
Press the ESC button to cancel
Pressing the ESC button once more returns you to the previous menu level.
easyE4 10/19 MN050009 EN www.eaton.com
Opens additional menus
Table 55: System options
SECURITY
SYSTEM
MENU LANGUAGE
DELETE PROGR.
NET
ETHERNET
UPDATE
Table 56: System option-
s\Delete progr.
DELETE PROGR.?
YES
NO