Eaton easyE4 Manual page 151

Hide thumbs Also See for easyE4:
Table of Contents

Advertisement

Figure 72: Lighting control circuit
Figure 73: Circuit diagram with inputs I01, I02 and output Q1
Now wire the circuit diagram as described below.
With this example the switches S1 and S2 are at the input.
switch contacts for the input terminals in the circuit diagram .
The relay Q1 is represented in the circuit diagram by the relay coil
The symbol identifies the coil's function, in this case a relay coil acting as a contactor.
is one of the easyE4device's outputs.
Q001
From the first contact to the output coil
With easyE4 devices wire from the input to the output. The first input contact is
Press the OK button.
easyE4 will insert the first contact,
The
flashes and can be changed, for example,
I
to a
for a button input by using the cursor buttons
P
be changed at this point.
easyE4 10/19 MN050009 EN www.eaton.com
, at the cursor position.
I001
or . However, nothing needs to
4. Operation
4.5 Your first EDP program
and
are the
I001
I002
.
Q001
I001
.
147

Advertisement

Table of Contents
loading

Table of Contents