Eaton easyE4 Manual page 410

Hide thumbs Also See for easyE4:

Table of Contents

6. Function blocks

6.1 Manufacturer function blocks

6.1.5.4 MX - Data multiplexer

easyE4 base devices provide 32 data multiplexer function

blocks, MX01 through MX32. You can use a data multiplexer to

select a value from eight input values, I1 through I8. The func-

tion block will then provide this value at output QV for further

Use input K (channel number) to specify which input will be

connected through to the output. Channel number 0 will con-

nect input I1 to QV, while channel number 7 will connect input

The MX data multiplexer can be used for the sequential control

of up eight to positioning sections that are transferred to the I1

input of the PO Pulse output function block.

Operating principle

If there is a signal state of 1 at the EN coil, the data value of the operand connected to

input Ix will be connected through to output QV. In this case, the value at function block

input K will reference input Ix.

You can change the channel number and accordingly connect a different input value

through to QV even when the EN input is set.

If there is a signal state of "0" at the EN coil, output QV will be set to a signal state of "0".

The function block will carry out a selection of one out of eight.

The function block and its parameters

Function block inputs

1: Activates the function block.

Channel number

References the function block input you want

(I1 through I8).

easyE4 10/19 MN050009 EN www.eaton.com

Function Block Input

The checkbox for the

Function block release by EN is

parameter must first be enabled

Integer value range: 0...7

Chapters

Table of Contents