Eaton easyE4 Manual page 106

3. Commissioning
3.5 Establishing an Ethernet connection and transferring a program
102
Prerequisites that must be met in order to be able to access an easyE4 control relays:
The PC must have an Ethernet port that is free and has been configured
l
The PC's Ethernet port must be on the same subnet as the easyE4 base device.
l
The easyE4 control relays must be connected to the PC with a standard Ethernet
l
cable featuring an RJ45 connector
An Ethernet address must have been assigned to the easyE4 base device via
l
DHCP, auto-IP, or manually.
For devices with a display, write down the address of the easyE4 base device by
going to INFORMATION\ACTUAL CONFIG and scrolling to IP ADDRESS.
Open the Communication view in the easySoft 7 programming software.
Communication view
Communication\Connection view
Figure 56: Establish Ethernet connection
easyE4 10/19 MN050009 EN www.eaton.com