Eaton easyE4 Manual page 439

No edge evaluation of T bit
input
Write data to NET after each ...
<n> cycle
Parameter display
+ Call enabled
Simulation not possible
Other
Retention
The function block does not recognize retentive data.
See also
→ Section "GT - Get values from NET", page 428
→ Section "PT - Put values to NET", page 432
→ Section "Setting up a NET", page 625
easyE4 10/19 MN050009 EN www.eaton.com
6.1 Manufacturer function blocks
Description
When this checkbox is enabled, the
data will be transmitted to the NET
based on cycle times. It will be
transmitted every nth cycle, where n
can be defined in the parameters for
the function block.
If the checkbox is disabled, manual
transmission triggering with an edge
at function block input T_ will be
required.
Can only be selected if No edge
evaluation of T bit input is enabled.
Constants can be edited on the
device, as can function block para-
meters when using the EDP pro-
gramming language.
6. Function blocks
Note
to 0 or 1 depending on the func-
tion block.
435