Eaton easyE4 Manual page 278

6. Function blocks
6.1 Manufacturer function blocks
274
Function block outputs
Description
(Bit)
Q1 1: During the time between sunrise and sunset
E1 Error
1: If the device location's latitude exceeds the
value range – please refer to Project view/C-
lock tab
or if O1, O2 exceeds the value range.
(DWord)
T1 Hours in the switch-on time calculated on the
basis of the calculated sunrise and the value at
O1
T2 Minutes in the switch-on time calculated on
the basis of the calculated sunrise and the
value at O1
T1 Hours in the switch-off time calculated on the
basis of the calculated sunset and the value at
O2
T1 Minutes in the switch-off time calculated on
the basis of the calculated sunset and the
value at O2
Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
MB, MD, MW - Markers
NB, NW, ND - NET markers
NET stations n
QA - Analog output
I - Value input of a FB
2) Only on projects with ≥ 2 base devices on NET
You can assign the following operands to the function block outputs that are bit outputs:
Assigning operands
M - Markers
SN - Output bit via NET (send)
bit via NET (send)
2)
N - Network marker bit
LE - Output backlight
Q - Bit output
I - Bit input of a FB
2) Only on projects with ≥ 2 base devices on NET
easyE4 10/19 MN050009 EN www.eaton.com
Value outputs
x
2)
x
x
x
Bit outputs
x
2)
SN - Output x
x
x
x
x
Note
Integer value range starting from the
prime meridian:
Longitude
-180...+180 (W...O)
Latitude
-89.899...+89.899 (S...N)
(-89°54'...+89°54')
Integer value range:
0...23
Integer value range:
0...59
Integer value range:
0...23
Integer value range:
0...59