Startup Behavior Of Easye4 Control Relays With A Display And Keypad - Eaton easyE4 Manual

3. Commissioning
3.3 Switch on

3.3.2 Startup behavior of easyE4 control relays with a display and keypad

90
If there is no program, the control relay will start in STOP mode.
All the information on the display will be shown in English if the device is configured
with its factory settings.
If there is an executable program on the easyE4 control relays, the device will start in
RUN mode.
In addition to having a valid program on the control relay, please make
sure that there are no peripheral faults that will lead to STOP mode.
easyE4 base device with integrated display
If there is no splash screen on the memory card
l
after being switched on, the easyE4 base device will show the Eaton
logo and then the status display. This status display provides inform-
ation on the device's status.
If there is a splash screen on the memory card
l
after being switched on, the easyE4 device will show the splash
screen and then the status display. This status display provides inform-
ation on the device's status.
If there is no executable program on the easyE4 control relays, the device will start in
STOP mode.
All the information on the display will be shown in English if the device is configured
with its factory settings. Once the device is ready for operation, the status display will
appear.
Figure 50: Example of status display on display
easyE4 10/19 MN050009 EN www.eaton.com