Eaton easyE4 Manual page 681

Example: Sending an email with alarm function block AL
You now expand the previous example → chapter "10 E-mail function", page 670 by
adding an alarm function block AL.
After pressing the P button P1 on the easyE4 base device, the easyE4 should send an
email.
Precondition:
You have created a project using the example Sending email with easyE4 when the
operating mode changes.
To complete this example, follow the steps below:
Program and configure the alarm function block
Make sure that the project from the example Sending email with easyE4 when the
operating mode changes is open.
Switch into View programming.
Select the alarm function block AL from the catalog and left click it to drag it to the
workspace.
Select the alarm function block AL N/O from the catalog left click it to drag it to the
workspace at input T_ of the AL01 function block.
In the Contact tab in the selection list, select operand P- device key.
Make sure that number 1-< is selected in the selection list.
Left click on the alarm function block AL01. The tab Alarm function block para-
meters opens.
In the field Subject, enter a text that describes the trigger event.
In the field Message text enter any text with a maximum of 160 characters.
Make sure that the ID of the desired recipient group is entered in the selection field
Recipient assignment. Which recipient is assigned to which recipient group is
defined in Project view/Email tab.
easyE4 10/19 MN050009 EN www.eaton.com
10. Connection to other devices
10.5 E-mail function
677