Eaton easyE4 Manual page 496

6. Function blocks
6.1 Manufacturer function blocks
492
Other
Linking and parameter setting
In the function block diagram view, drag the function block to the position you want.
Then go to the Jump label parameters tab and select the same function block number
you originally assigned to the corresponding conditional jump function block.
You can also move this function block later on. To do so, right-click on the function block
you want to move and then select the Move... option.
See also
→ Section "AL - Alarm function block", page 440
→ Section "BV - Boolean operation", page 444
→ Section "D - Text display", page 448
→ Section "D - Text display editor", page 458
→ Section "DL - Data logger", page 475
→ Section "JC - Conditional jump", page 486
→ Section "MR - MasterReset ", page 493
→ Section " NC - Numerical converter", page 497
→ Section "ST - Set cycle time", page 503
easyE4 10/19 MN050009 EN www.eaton.com