Typical Installation Example - ABB MicroFlex e190 User Manual

48 Planning the electrical installation


Typical installation example

DO NOT TOUCH!
Brake resistors can become
extremely hot! Locate away from
CAUTION
vulnerable components and wiring.
Connect AC power cable shield to metal panel, using
conductive shield earth/ground clamps.
On painted panels, remove paint to expose bare metal.
AC power wires should be as short as possible, typically
less than 0.3 m (1 ft).
Longer wires must be shielded as shown.
Wire colors may vary according to region.
Protective
Earth
(PE)
Footprint filter OFI-01
saves panel space.
The filter can be inverted
if the AC input is above
the drive.
Drive earth wire
must be at least
2
10 mm (7 AWG)
Installation
cabinet
'star point'
AC power
from fuses
or reactor