Direct Wall Mounting; Mains Filter Installation; Braking Resistor Installation - ABB MicroFlex e190 User Manual

40 Mechanical installation


Direct wall mounting

1. Mark the locations for the two holes. The mounting points are shown in
dimensions on page 35.
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the wall. Note: Only lift the drive by its
chassis.
4. Tighten the screws.


Mains filter installation

See the chapter Mains filters


Braking resistor installation

See the chapter Resistor braking
on page 165.
on page 171.
Main