Contents Of This Manual - ABB MicroFlex e190 User Manual

22 Introduction to the manual

Contents of this manual

The manual consists of the following chapters:
• Safety (page 13) gives safety instructions you must follow when installing,
commissioning, operating and servicing the drive.
• Introduction to the manual
audience, purpose and contents of this manual. It also contains a quick
installation and commissioning flowchart.
• Operation principle and hardware description
principle, connector layout, type designation label and type designation
information in short.
• Mechanical installation
unpack, check the delivery and install the drive mechanically. It also provides the
dimensions of the drive.
• Planning the electrical installation
AC supply, cabling and RCDs.
• Electrical installation: AC input / DC input, motor and brake
the installation of high power connections including the AC supply, motor output,
brake resistor, and optional DC supply / sharing.
• Electrical installation: input / output
power connections, including analog and digital input/outputs (including Safe
Torque Off), motor feedback and Ethernet.
• Installation checklist
physical installation has been completed correctly.
• Start-up (page 93) describes the steps for applying power to the drive, installing
the Mint Machine Center software, and tuning and optimizing the motor/drive
combination.
• Fault tracing (page 109) describes the drive's LED indicators and provides
solution to common problems encountered during installation.
• Maintenance (page 141) describes the maintenance required to maintain
optimum performance from the drive.
• Technical data
the dimensions, ratings, technical specifications, and provisions for fulfilling the
requirements for CE and other markings.
• Mains filters (page 165) describes optional mains filters that can be used with the
drive.
• Resistor braking
choppers and resistors.
• Accessories (page 179) describes additional components that are useful for the
drive installation.
• Appendix: Safe Torque Off (STO)
and technical data.
(this chapter, page 21) describes applicability, target
(page 33) describes how to check the installation site,
(page 91) provides a list of checks to confirm that the
(page 147) contains the technical specifications of the drive, e.g.
(page 171) describes how to select, protect, and wire braking
(page 187) describes STO features, installation,
(page 27) describes the operation
(page 41) describes the requirements for the
(page 59) describes the installation of low
(page 49) describes