Functional Safety Standards; Rcm Marking; Ce Marking; Compliance With The European Emc Directive - ABB MicroFlex e190 User Manual



Functional safety standards

EN 61508:2010,
Parts 1, 2
EN 61800-5-2:2007
IEC 61800-5-2:2016
EN ISO 13849-1:2015
EN ISO 13849-2:2012
EN 62061:2005 +
A1: 2013 + A2: 2015

RCM marking

RCM marking is required in Australia and New Zealand. A RCM mark is
attached to each drive in order to verify compliance with the relevant
standard (IEC 61800-3, Adjustable speed electrical power drive systems -
Part 3: EMC product standard including specific test methods).

CE marking

A CE mark is attached to the drive to verify that the unit follows the provisions of the
European, EMC, and machinery directives.
CE Declaration of Conformity
The declaration (3AXD10000540159) is available on the internet. See
library on the Internet

Compliance with the European EMC Directive

The cabinet builder is in responsible for the compliance of the drive system with the
European EMC Directive. For information on items to consider, see:
• Subsections Compliance with EN 61800-3, category C2 & C3
with EN 61800-3, category
• The chapter Planning the electrical installation
• Technical Guide No. 3 – EMC Compliant Installation and Configuration for a
Power Drive System (3AFE61348280 [English]).
Definitions
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment.
Likewise, the equipment must not disturb or interfere with any other product or
system within its locality.
Functional safety of electrical/electronic/programmable electronic
safety-related systems
Adjustable speed electrical power drive systems: Safety requirements,
Functional
Safety of machinery: Safety-related parts of control systems. Part 1:
General Principles for Design
Safety of Machinery: Safety-related parts of control systems. Part 2:
Validation
Safety of machinery: Functional safety of safety-related electrical,
electronic and programmable electronic control systems
on page 209.
C4, below.
Technical data 161
and
in this manual.
Document
Compliance