Start-up
What this chapter contains
This chapter describes software installation and the start-up procedure of the drive.
Safety
WARNING! Read the
before performing any maintenance on the equipment. Ignoring the safety
instructions can cause injury or death.
Introduction
Before powering the MicroFlex e190 you must connect it to the PC using an Ethernet
cable and install the Mint WorkBench software on the PC. This includes a number of
applications and utilities to allow you to configure, tune and program the
MicroFlex e190. Mint WorkBench and other utilities can be downloaded from the
pages of
Connect the MicroFlex e190 to the PC
Connect a CAT5e Ethernet cable between the PC and the MicroFlex e190 E3
Ethernet port on the front panel. Do not connect the cable to the E1 or E2 ports on the
top of the drive.
NOTE! You cannot connect an ordinary office PC to the MicroFlex e190
without first altering the PC's Ethernet adapter configuration. See
the PC Ethernet adapter
Safety
instructions on the first pages of this manual
on page 94.
Start-up 93
9
Configure