Enable The Ethernet Adapter For Mint Workbench; Start The Microflex E190; Preliminary Checks; Power On Checks - ABB MicroFlex e190 User Manual

Enable the Ethernet adapter for Mint WorkBench

Before Mint WorkBench can use the Ethernet adapter to discover the
MicroFlex e190, the adapter must be enabled in the Mint Sidebar.
1. On the Windows 7/10 task bar in the notification area, right-click the Mint HTTP
Server icon and choose Properties. (Windows 8.1: On the Start screen, click the
Desktop icon to access the desktop first.)
2. In the Discovery area, check the required local area connection, then click OK.
Note:If the Mint Sidebar can't discover the drive then you may need to disable or
modify your Firewall and/or Anti-virus settings.

Start the MicroFlex e190

If you have followed the instructions in the previous sections, you should have now
connected the power sources, your choice of inputs and outputs, and the Ethernet
cable linking the PC to the MicroFlex e190.


Preliminary checks

Before you apply power for the first time, check all items in
starting on page 91.


Power on checks

See section Drive status display
detected a fault.
1. Turn on the 24 V DC control circuit supply (if present).
2. Turn on the AC supply (or DC supply, page 54).
3. The drive status display shows a test sequence which normally takes
approximately 15-20 seconds. The sequence ends with the
STO input (page 187) is not powered. Start-up can take more than 1 minute after
downloading new firmware.
4. To allow the Commissioning Wizard to function, the Safe Torque Off inputs (page
187) must be powered to allow the MicroFlex e190 to be enabled.
on page 114 for symbols that show if the drive has
Start-up 95
Installation checklist,
symbol, or if an