Feedback Cables; Ethernet Cables - ABB MicroFlex e190 User Manual

184 Accessories


Feedback cables

The part number for a feedback cable is derived as follows:
CBL 020 SF
m SF
BSM servo motor
ft
feedback cable with at
least 1 connector
2.5
8.2
WF
5.0
SDM servo motor
16.4
feedback cable with at
7.5
24.6
least 1 connector
10
32.8
DF
15
Servo motor feedback
49.2
cable with drive
20
65.6
connector only
30
98.4
RF
Raw cable
(no connector)
Other lengths available on request
Example:
A 2 m encoder feedback cable for a MicroFlex e190 drive, with required connectors at both ends, has part number
CBL020SF-E2.
These feedback cables have the outer shield tied to the connector housing(s). If you
are using an alternative cable with your chosen feedback device, be sure to obtain a
cable that is a shielded twisted pair 0.34 mm
overall shield. Ideally, the cable should not exceed 30.5 m (100 ft). Maximum wire-to-
wire or wire-to-shield capacitance is 50 pF per 300 mm (1 ft) length, to a maximum of
5000 pF for 30.5 m (100 ft).


Ethernet cables

The cables listed in this table connect MicroFlex e190 to other Ethernet nodes such
as the controller, additional MicroFlex e190s, or other Ethernet compatible hardware.
The cables are standard CAT5e shielded twisted pair 'crossover' Ethernet cables:
Cable description
CAT5e Ethernet cable
-E 1 S
B
BiSS
D
EnDat
SinCos
E
Incremental
encoder
S
SSI
A
Smart Abs
R
Resolver
CBL002CM-EXS
CBL005CM-EXS
CBL010CM-EXS
CBL020CM-EXS
CBL050CM-EXS
CBL100CM-EXS
CBL200CM-EXS
-
Raw cable
1
Legacy
controllers
2
e100 / e150
e180 / e190
2
(22 AWG) wire minimum, with an
Part
-
Standard
connector
S
Stainless steel
connector
Length
m ft
0.2 0.65
0.5 1.6
1.0 3.3
2.0 6.6
5.0 16.4
10.0 32.8
20.0 65.6