Installing The Graphtec Studio - GRAPHTEC FC8600 SERIES Setup Manual

To connect using the RS-232C cable
2
Connect the Plotter to the PC using the RS-232C cable,
and turn on the Plotter power source.
Connect it to
the Plotter.
3
Check the machine for RS-232C setting.
4
Select the Interface.
4.

Installing the Graphtec Studio

1
Click the [Setup Graphtec Studio] on the "Start" screen of
Installer.
Connect it to the PC
RS-232C cable
Press Power switch " | ".
Select the "COM1:
(Communication port)"
from Pull down list.
Click the [Next].
Click the [OK].
Setting the port of PC
When RS-232C is used to connect, the port setting
for between PC and this machine should be
matched. For the port setting with PC, see Help in
Windows.
When normally installed
"Start" → "Control panel" → "Hardware and Sound"
→ "Graphtec FC8600" appears on "Devices and
Printer". (For Windows 7)
For the Macintosh
See User's Manual contained in each language
folder inside attached DVD-ROM.
15