Laser Unit Section; Image Transfer Section - MINOLTA-QMS Magicolor 2200 Series Manual

3-16 Laser unit section

1. Remove the laser unit connector
2. Remove the laser unit cover
3. Remove the laser unit

3-17 Image transfer section

1. Remove the image transfer roller pressure solenoid
1. Remove the rear cover.
2. Remove the 2 laser unit connectors from the PWB-A circuit board
and pull them out from the harness duct.
1. Spread out a any absorbing material on the left side and tip left side
of the printer down and over on its side.
2. Remove the 2 set screws for the laser unit cover.
1. Remove the 4 set screws for the laser unit. One of the screws is for
the grounding strip.
Never turn on the power with the unit in this condition. Invisible laser
light that can cause blindness will be emitted.
1. Remove the cover for the paper take-up section.
2. Remove the 1 set screw and 1 connector for the image transfer
roller pressure solenoid.
D-19