MINOLTA-QMS Magicolor 2200 Series Manual page 92

4. Remove the upper cover
5. Remove the left cover
6. Remove the rear cover
7. Remove the left rear cover
1. Remove the rear connector cover.
Connector
2. Remove the 2 set screws for the top cover (right rear of the main
cover
unit, 1 screw inside the connector cover and 1 screw under the con-
trol panel).
3. Loosen the top-right set screw on the rear cover.
4. Remove the hook at the front center from the frame and remove the
cover by pulling it to the right.
1. Remove the 3 set screws for the left cover.
2. While pulling the left cover forward, lift it up and then push the
cover down and remove the 3 hooks at the bottom.
3. Pull the left cover downward to remove the 3 hooks at the top.
Do not forget to mount the reinforcement plate when reassembling the
printer.
1. Remove the 13 set screws for the rear cover.
• The area indicated by the arrow in the drawing to the left uses a
serrated washer.
1. Remove the 4 set screws for the left rear cover.
• The area indicated by the arrow in the drawing to the left uses a
serrated washer.
D-8