MINOLTA-QMS Magicolor 2200 Series Manual page 148

Paper exit sensor adjustment
(1) Turn on the power supply.
(2) While pressing SW1, switch SW2-1 to on. LD1 will flash to indicate that the test mode has operated.
(3) Starting with VR1 turned all the way to the left, turn it to the right (clockwise) and record when the LD2 changes
from off to on. This is position (H).
If LD2 does not come on when VR1 is turned all the way to the right, that position is (H).
(4) Open the door and insert a A4 or Letter sheet of paper into the paper passage for the 5 bins.
(5) Turn VR1 to the left (counterclockwise) and record when LD2 changes from on to off. This is position (L).
If LD2 does not change from on to off when VR1 is turned all the way to the left, that position is (L).
(6) Set VR1 between (H) and (L) position and check that (LD2) goes from off to on.
(7) Remove the sheet of A4 or Letter paper and check that (LD2) goes from on to off.
(8) Switch SW2-1 to off and check that all LEDs have gone out.
E-34