MINOLTA-QMS Magicolor 2200 Series Manual page 141

5-6-2 Service Call 15 XFER BELT CLN (Belt cleaner pressure error
No.
1. Does the belt cleaner motor operate during print-
ing? (Check by sound, or remove the left cover
and look in from the lower front to check the
operation of the lever.)
2. Turn the cam gear by hand and check if the sen-
sor light breaker plate stops the light.
Others
Belt cleaner pressure detection is performed during color printing and during special printing contact and release opera-
tions.
A belt cleaner error is detected when there has been no change at the belt cleaner release sensor (PC16) within the spec-
ified time after the start of belt cleaner motor operation.
Belt cleaner pressure error detection
Belt cleaner motor
H
PC16
L
Check
ON
Specified time
OFF
E-27
Result Corrective action
No Ensure the connection of the connectors
(PJ32A and PJ33A) are secure.
Ensure the connection of the connectors
(PJ51 and PJ61) are secure.
Yes Replace the belt cleaner release sensor.
Replace PWB-A
Specified time
Release
Error detection
)